Cierva C-30 ARF Autogyro

Flying Styro Cierva C 30 Autogyro - 21-1/2" in length, 3" wide, 9" high, rotor span 26-3/4", 14 oz. flying weight. The "Cierva C 30" is a hybrid, part helicopter and part airplane. It was produced from 1933 until 1945 and used for aerial observation and also served on aircraft carriers. Construction is straight forward but more involved than some of the other Flying Styro models. All foam parts are molded and come pre-painted. Kit includes all hardware, pushrods, balsa blades, foam wheels, landing gear struts and prop adapter. A scale molded pilot figure is also included as well as the complete radial engine. You will need to install your radio gear, 2 mini servos, a 12 amp speed controller and at least a 4 channel receiver with delta mixing. Using the recommended motor and 7x4 prop with a 1320 mAh 3-cell lithium polymer battery, you can expect 10-15 minutes of flying time. Comes with photo illustrated instruction manual and water-slide decal set.

Recommended Equipment:

• Radio - HTR971T Hitec Neon 3 FM, Micro 05 Receiver, 2 HS-55 Servos
• Motor - MMC115 LittleScreamers "DeNovo" Brushless Outrunner
• Speed Control - JEE012 Jeti ECO 12 Amp Brushless Controller
• Battery - TP13203 Thunder Power 3 Cell 1320 11.1V LiPoly Pack
• Charger - ETC2500 Smart Charger for 1-4 LiPo Cells
• Prop - P07040SF APC 7x4 Slowflyer Prop
• You will also need some solder, 5-min. epoxy, and connectors

Here's how the Silver C-30 comes out of the box.	Here's how the Blue C-30 comes out of the box.