![]() |
EnerLand "Twenty"
& "Twenty-Five"
Li-Poly Battery Packs |
|
| Home | LiPo Chargers | Cell Balancers | LipoSack | CellMeter | ||
The BEST Lipo pack you can buy -
and,
can you believe the LOW PRICES?
![]() |
|
All PolyQuest brand lipoly battery packs are now EnerLand! Best? All EnerLand "Twenty" brand lipoly packs can be discharged at a rate 20 times their capacity. Example: a 1200 mAh (1.2 Amp hour) pack can be discharged at 24 amps and a 3700 mAh pack at 74 amps continuous. This is NOT the peak discharge rate; it is the rate that these packs can be discharged at CONTINUOUSLY. "Twenty-Five" brand lipo packs can be discharged at a rate 25 times their capacity. All EnerLand packs 800 mAh and larger have a connector that plugs into the PCM Guards (sold separately). The PCM (Protective Circuit Module) Guards prevent you from destroying your battery by accidental overcharging. Overcharging can ruin your battery and cause a fire. EnerLand's unique welding process allows packs to put out more power, and the packs larger than 800 mAh have between-cell ventilation which gives longer pack life. Check out the LiPoly Balancer to cell balance your EnerLand packs. |
|
300 mAh packs, discharge at up to 6 amps |
|
![]() |
|
400 mAh packs, discharge at up to 8 amps |
|
![]() |
|
800 mAh packs, discharge at up to 16 amps |
|
![]() |
|
|
1200
mAh packs, discharge at up to 24 amps
|
|
![]() |
|
1500 mAh packs, discharge at up to 30 amps |
|
![]() |
|
1800 mAh packs, discharge at up to 36 amps |
|
![]() |
|
2150 mAh packs, discharge at up to 43 amps |
|
![]() |
|
2500 mAh packs, discharge at up to 62.5 amps |
|
![]() |
|
3300 mAh packs, discharge at up to 82.5 amps |
|
![]() |
|
3700 mAh packs, discharge at up to 92.5 amps |
|
![]() |
|
4350 mAh packs, discharge at up to 108.75 amps |
|
![]() |
|
5000 mAh packs, discharge at up to 125 amps |
|
![]() |
|
![]() |
|
Overcharging a Lithium battery is dangerous, it can ruin the battery and can cause a fire. PCM Guard monitors each cell in the pack and will disconnect the battery pack from the charger if any cell exceeds 4.2 volts. Order the PCM Guard that matches the number of cells in series in your pack. |
|
![]() |
|
Charging Lithium Polymer batteries just got safer |
|
|
LipoSack - 9" wide and 12" long, weighs 4 oz. LipoSack will allow you to charge most Lithium Polymer packs and reduce the effects of a Lithium Polymer battery charging mishap. Place LipoSack on a non-flammable surface during charging process. Route charging leads through vent at the top seam of the LipoSack. Close top flap of LipoSack and press hook and loop closure. Charge your battery using proper charging practices. Always monitor your charging batteries and never leave them unattended. |
|
Phone: 1-866-WE-FLY-RC (1-866-933-5972)
Fax: 615-377-6948
Copyright © 1996-2008 Hobby Lobby International, Inc. All Rights Reserved.