Programming Card, 90 Amp

Spare Programming Card, 90 Amp

1-1/4" x 1-7/8" x 1/16" card with jumper connectors programs the 90 Amp Atlas controllers. Pick the program options that you want by moving the jumpers to the appropriate pins on the card, plug your Atlas controller into the Program Card, switch on the controller for a few seconds and your settings have been programmed; a "Beep" tone verifies the process. A 4.8V receiver battery is required to program the Opto controllers. Changes take only seconds to perform; no other support equipment or computer is required.

Atlas Black Controller PDF Instruction Manual