 | Jason Says: | | "Add this to retracts or flaps to slow down the travel to scale speeds. Makes it look so good." |
|
Adjust the speed of a servo |
1-1/4 x 7/16 x 3/16" (30 x 10.5 x 6mm), weighs 3.6 grams. Tiny unit allows you to adjust the speed of any proportional servo from.7 seconds to 14.7 seconds in 16 steps. Plug module into the receiver channel that you want to control, plug the servo into module, and adjust the speed using the screw on the side of module. Great for setting scale speed on retracts (with proportional servo) or scale speed for operating flaps. The longer transition times are ideal for marine models. Can be used to slow the operation of 2 servos with the addition of a "Y" connector.
I've got these installed in two airplanes: One is used through a y-cable for two flap servos on a .25 size DHC-2 Beaver and the other is used on a single flap servo on a .25 twin engine Deuces Wild. They make engaging flaps both scale looking and stress free. The transition to flaps is gentle, no sudden pitch up or need to program in elevator trim to compensate. So far they have operated perfectly through many flights, moving my flaps up and down, flawlessly. I keep them set at the slowest rate which works perfectly for my tastes.
|
|
Read All Reviews...
|
Please call our support line toll free: (866) 512-1444 for assistance with this product
|