Super Dimona 2400 RC Model Glider (OVERSIZE)

Semi-scale motor glider for powered or thermal flying

94-1/2" wingspan, 43" long, 625 sq. in. wing area, 65 oz. flying weight. The factory did the hard work for you. Fuselage, wheel pants and winglets are gel-coated fiberglass. Wings and stabilizer are pre-built and covered conventional wood construction. Flying surfaces are pre-hinged. Servo mounts, landing gear mounts, pushrods and wing connecting spar tube are pre-installed. The nose gear is steerable. Assembles quickly, clear photo-illustrated instructions. Removable clear canopy and cockpit interior provides easy access to the equipment and flight batteries. Powered as we recommend the model will take off of a short runway and climb steeply. Turn the motor off and enjoy the thermal performance. Flight times of over 30 minutes are easily achieved with a little thermal help. Easy to build and fly. For 4 channels: Ailerons (2 servos), Elevator, Rudder (and nose wheel steering), and Throttle.

Radio
1 - HTR971B Laser 4 Channel FM with 2 HS-322 Servos
2 - HTS055 Hitec HS-55 Servos
2 - HLAE320 24" Extension for Hitec/JR
1 - HT0096 Hitec Aileron "Y" Connector

Motor/Prop
1 - PM282010 AXI Gold 2820/10 Outrunner Motor
1 - HLAN2954 10.5x6 Carbon Fiber Electric Flight Prop
1 - GR1385/42 42mm for 5mm shaft & 8mm prop hole

Motor Controller
1 - JAP40 Advance Pro 40 Amp Brushless Motor Controller
1 - JAP01 Jeti Advance Pro Program Card * optional

Battery
1 - TP33003SPL2 3 Cell 11.1V 3300 mAh Pro Lite V2 20C LiPo

Charger
1 - SRC506 iC6 LiPlus Intelligent Balance Charger

Accessories
Glue, Solder, Connectors, etc.