A-4 Skyhawk Ducted Fan Jet

Ducted fan jet with amazing performance

22" wingspan, 29" long, 155 sq. in. wing area, 16 oz. flying weight. All hollow molded foam construction, completely pre-painted and ready for assembly. The surface of the foam is toughened and the areas on the bottom of the jet that contact the ground are made of tough plastic. The ducted fan unit is included (ALF5101). The flight performance of this jet is simply amazing; it can easily rise off grass, and with our recommended JetScreamer motor the speed is blistering. Vertical performance is unlimited (OK, it is limited, but only by the pilots ability to keep the airplane in sight). The delta wing is very gentle in stall and slows well for soft landings. Slow speed performance is excellent and hand launching is easily done. With the addition of the optional wheel kit (ALF104W) take offs and landings from smooth surfaces are possible. Assembly is fairly easy; the wing is one piece and is glued to the fuselage after the aileron servo is installed. The ducting is smooth and elegant in design. The canopy is pre-done and is held in place by a magnet giving quick and easy access to the flight battery. Balance is critical on this airplane. The optimum balance point is molded into the bottom surface of the wing for easy reference. Waterslide decals for 3 versions of the A-4 are provided along with helpful instruction on their application. Total assembly time is about 6-8 hours. For 3-channels: Ailerons, Elevator and Throttle.

Radio
1 - HTR48725 Hitec 3 SS, Micro 05 Receiver, 2 HS-55 Servos
2 - HTS055 Hitec HS-55 Servos

Motor/Ducted Fan
1 - MMC5156 LittleScreamers "JetScreamer" OUTRUNNER w/21mm Adapter
1 - ALF51013 Alfa Rotor Plug for 3mm Shaft
1 - ALF51031 Alfa 5 Bladed Rotor * optional upgrade
3 blade ducted fan unit included in kit!

Motor Controller
1 - SPIN22 Jeti SPIN 22 Amp Electronic Speed Control
1 - SPINBOX Jeti "SPIN BOX" Programming Control

Battery
1 - TP21003SPL2 3 Cell 11.1V 2100 mAh LiPo

Charger
1 - ETC2500 LiPo Smart Charger for 1-4 Cells
1 - BAT220 Charger Adaptor, JST to Deans Ultra

Accessories
Glue, Solder, Connectors, etc.