Aero Master ARC Sailplane

Self-launching sailplane - fly all day on a single charge

97-3/4" wingspan, 49-3/4" long, 685 sq. in. wing area, 58 oz. flying weight. Over 8-foot wingspan sailplane with a wing loading of about 12 oz./sq. ft. and enough power to climb to thermal altitude in seconds. Gloss gel-coated lightweight fiberglass fuselage with a perfect finish, no painting required. Wings are of built up construction with full balsa sheeting, lightweight and strong. Ailerons are pre-cut in the outer wing panels as is the location for the aileron servo. Outer and inner wing panels must be glued, a carbon joiner is provided. Wings slip onto steel joiner rods and are removable for easier transport and storage. Stabilizer and elevator are attached to the fin by screws and are removable. The large tinted canopy gives you great access to the flight batteries and the radio components. Assembly is aided by clear line drawings with all the important dimensions shown. Motor is easily installed in the power pod through the access hatch on top. Wings, Stabilizer and Rudder must be covered with heat shrink covering (White and Yellow covering are included in the Accessory Pack below). Sailplane is easy to hand-launch and can even "Rise-off-Ground" if the grass is short. Climbs are steep, taking the sailplane to thermal altitude in 15 to 30 seconds and there is enough power in the batteries to give climb after climb. With just a small amount of thermal help, hours of soaring flight are possible from a single charge. For 4-Channels: Ailerons (2 servos), Elevator, Rudder and Throttle.

Radio
1 - HTR8725 Optic 6 Ch. Transmitter Only with Spectra
1 - RCD268 Neutron 6S Micro Rx
2 - HTS081 Hitec HS-81 Micro Servo
2 - HTS085 HS-85 Mighty Micro Ball Bearing Servo
2 - HT0604 12" Aileron Extension w/Gold Pins
2 - HT0605 24" Aileron Extension w/Gold Pins

Motor/Prop
1 - PM282012 AXI Gold 2820/12 Outrunner Motor
1 - HLAN5535 42mm 3 Blade Spinner for 5mm Shaft
1 - HLAN4233 3 Blade Middlepart Yoke, 47mm
2 - HLAN3423 9x7 Carbon Fiber Cam Blade

Motor Controller
1 - JESAP40 Advance PLUS 40 Amp Brushless Motor Controller
1 - JESAP01 Jeti Advance PLUS Program Card * optional

Battery
1 - PQ37003 Enerland 3 Cell 3700 mAh 11.1V LiPo
1 - ETC505 2-5 Cell LiPoly Smart Balancer & Charge Guard

Charger
1 - HT9253 Multicharger LiPo/Ni Charger
1 - PC001E Charger Lead with Deans Ultra Connector & Banana Plugs

Accessories
1 - HLAN1318AP Accessory Pack for Aero-Master
Glue, Solder, Connectors, etc.