"Electro Trainer" RTF Aileron Trainer

41-3/4" wingspan, 32-1/4" long, 264 sq. in. wing area, 25 oz. flying weight. You can get this airplane ready for flight in less than an hour. It's all molded foam so you will have very little assembly work to do. All radio components are pre-installed and ready for use. The 4 micro servos; rudder, ailerons (2), and elevator come ready-installed and connected to the control surfaces and steerable nose gear. The battery box is built into the underside of the plane for easy access to the battery. Attach the main landing gear, wing and wing struts. (The nose gear compresses realistically when it touches down during landing.) Charge the 3-cell LiPo flight battery from a 12 volt DC battery with the included cell balancing Lithium charger. This is a good airplane for a beginner. It has very gentle stall characteristics and good ground handling. The flying speed is moderate and you can do gentle aerobatics. You can fly it best in light wind or no wind.

Here's how it comes out of the box!

Check out the of the Electro Trainer!

Radio:
(Included and Installed)
72 mHz 4-Channel FM Transmitter, 6-Channel Receiver, 4 Micro Servos

Motor, Motor Controller:
(Included and Installed)
Brushless OUTRUNNER Motor and Brushless Speed Control

Battery:
(Included with the Airplane)
3 Cell 1800 mAh 11.1V Lithium Battery with Connector

Charger:
(Included with the Airplane)
12V DC Cell Balancing 2 to 3 Cell Lithium Battery Charger