F-16C Grey, ARF RC Jet

Light and fast - super flight with JetScreamer motor

24-3/4" wingspan, 33-3/4" long, 181 sq. in. wing area, 17 oz. flying weight. Alfa's F-16C is molded entirely from polystyrene foam and completely pre-painted, ready for assembly. Complete instructions are provided along with an exploded view drawing of the jet. The assembly is not difficult but prior building experience is recommended. Assembly will take 6-8 hours depending on choice of glues. Waterslide decals for the 90th Anniversary of the 111th Fighter Squadron are provided. This very colorful version of the F-16 is easier to see at a distance than the Camo Grey version.

A wide selection of motors can be installed in the included Alfa 60/15 Mark II ducted fan unit. We recommend the JetScreamer (MMC5156) for ballistic performance and jet-like speed. All aerobatic maneuvers are possible with the exception of those requiring a rudder. The F-16C is designed for hand launching and belly landing; the bottom of the fuselage has a plastic shell reinforcement to reduce wear. The landing speed is very slow when built to the recommended weight. Three micro servos are required: two for ailerons and one for elevator. The Alfa Model F-16C is also available in a Camo Grey version.

Radio
1 - SPM5500 DX5e Full Range Transmitter, AR500 Receiver, no servos
3 - HTS055 Hitec HS-55 Servos

Motor/Ducted Fan
1 - MMC5156 LittleScreamers "JetScreamer" OUTRUNNER w/21mm Adapter
1 - ALF51013 Alfa Rotor Plug for 3mm Shaft
1 - ALF51031 Alfa 5 Bladed Rotor * optional upgrade
3 blade ducted fan unit included in kit!

Motor Controller
1 - SPIN22 Jeti SPIN 22 Amp Electronic Speed Control
1 - SPINBOX Jeti "SPIN BOX" Programming Control

Battery
1 - TP21003SPL2 3 Cell 11.1V 2100 mAh Lipo

Charger
1 - SRC506 IC6 Balance Lipo Charger
1 - SRC513 PQ/HP Adapter for IC6 Charger

Accessories
Glue, Solder, Connectors, etc.