Electro Kadett

Designed as an electric airplane - Light and easy to fly

63" wingspan, 43-1/4" long, 744 sq. in. wing area, 57 oz. flying weight. 11 oz. per sq. ft. wing loading. Laser cut built-up balsa and plywood construction. The wings are rib and spar construction, completely pre-built and pre-covered. Motor cowl and wheel pants are pre-finished fiberglass. Landing gear is anodized aluminum. Laser cut motor mount is ready for your AXI motor. The correct side and down thrust is already built in. Flight battery is easy to install through the hatch under the nose.

A great second airplane with smooth and predictable flying characteristics. Lots of power for short take-offs even from the grass and so light it floats in slowly for easy landings. Very stable with a gentle stall and quick recovery. As easy to fly as a trainer but with enough power to practice more advanced maneuvers. Rolls, loops, inverted, even sustained knife-edge is easily accomplished. Photo-illustrated instructions are clear; assembly time is about 4-6 hours. Flight time is about 8-12 minutes. For 4 channels: Ailerons (2 servos), Elevator, Rudder and Throttle.

Radio
1 - SPM6600 Spektrum DX6i DSMS 6-Ch. Radio, AR500 Rx, no servos
2 - HTS225BB HS-225BB Mighty Mini Ball Bearing Servo
2 - HTS081 Hitec HS-81Servo

Motor/Prop
1 - AM292110 Atlas Outrunner 2921/10
1 - GR1385/45 45mm for 5mm shaft & 8mm prop hole
1 - PE11070E 11x7E Thin Electric Prop

Motor Controller
1 - ABC45 Black 45 Amp Brushless Controller

Battery
1 - TP33003SPL2 3 Cell 11.1V 3300mAh Pro Lite V2 20C LiPo

Charger
1 - SRC506 iC6 Balance charger for 1-6 LiPo Cells

Accessories
Glue, Solder, Connectors, etc.