Main Wing with Ailerons for Mini-Telemaster |
A simple direct replacement wing with strip ailerons, installs on your Mini-Telemaster with no modifications. The wing is the same size and area as the original wing. The dihedral has been reduced for use with ailerons. Comes in two panels, each pre-covered with the ailerons pre-hinged and torque rods in place. Wing joiner must be epoxied together and then the wing halves must be glued together with epoxy. An aileron servo must be installed (HS-81 servo not included) and connected to the aileron torque rods with the included hardware. 4-Channel radio required for this application. Decal set included.
I was getting set to build an aileron wing for a Simple series Cub which origonally is only three channel. Although the root dimension is not listed here, The area divided by the wingspan told me this wing should be very close to the Cubs root width. I got the Mini-T wing and Bingo, it's 1/16 inch narrower than the cubs, I'm in business. Both wing panels are straight. The covering is tops. The dihedral brace fits just right in the slot after just a tune up sanding. Now my Simple Cub can fly in a little more wind and be more aerobatic. When I consider the cost of balsa and cover film , cutting the parts, and the time to build-FORGET IT. So, if you have a simple series plane or the 3-ch Mini-Telemaster that you want to upgrade to ailerons-JUST DO IT.
|
|
Read All Reviews...
|
Please call our support line toll free: (866) 512-1444 for assistance with this product
|