This is an easy build and excellent performer. A particularly good value for the price.

The ESC does have an unusual one-time throttle calibration function when first connected to the radio/battery that can be very confusing and/or make you suspect a bad ESC. To avoid any confusion here, everyone should be reminded to read the ESC Manual PDF in the Support secton of this aircraft's webpage on the HL website. There is no mention of this in the directions for the aircraft.

Tough. Receiver lost signal twice. (orange 2.4. One with satellite, other without). Became a lawn dart at about 40 mph. Some glue and it is back up flying. Love the plane. Good speed. With throttle management, 6 minute flights aren't unusual. Flies like it is on rails. Very responsive. Sounds good. Looks really good doing through the air. Best 100.00 airplane I have bought.

*********CG was off. Set up per manual resulted in unflayable tail heavy plane. Stock battery and 1/2oz In the knose resulted in desired flight charcheristis.

From the 3 cell 1600 mAh lipo to the servos, ESC, motor, fan, control hardware, even the 5 minute epoxy included in the kit, these Hobby Lobby EDF park jets are winners. Apart from the radio and a few adhesive it is always a good value when everything you need to complete a flying model is in the box.

Some simple assembly tips I can offer. Use a toothpick to poke small shallow holes where the glue joints meet to strengthen them. Use red locktite to secure those servo push rod connectors. Don’t use alcohol to clean off the excess epoxy, it removes the paint.

I bought the Mig-15 and the F-86 in Aug/2011. Since then I must have 30 to 40 flights between both of them. The Mig-15 and F-86 both fly great. The Mig-15 is more durable than the F-86. On very short grass or short dry grass without the drop tanks the Mig-15 will roll off the ground in about 50' of runway, you can even do touch-and-go landings. While taxing or sliding on the ground there is a little directional control to taxi the Mig-15. At 350 watts the 64 mm EDF provides plenty of thrust to get you up and flying. I keep flight times down to a short 4 minutes.

For both the Mig-15 and F-86 I dialed in a little aileron differential to help with adverse yaw. Also as speed increases so will positive pitch trim. Dial in a switchable throttle-elevator mix, as the throttle stick advances pass 80% to full throttle the elevator comes down a little. This helps to keep high speed passes low and level and you can disable it for hand launches.

With any hand launch model you have to keep those hand launches straight and level. A few weeks ago (Aug/2012) I lost my Mig-15 due to a bad underhand launch. It pitched up into a bad stall and crashed nose first very hard. The same day I just had to order a replacement and another spare. From my experience, buy two. If you lose it, your going to miss it.

After building four and flying three of these EDF jets I can’t say anything negative. They look and fly great. Thanks Hobby Lobby.

Went together easily and runs good on the bench, but at the field it crashed 3 times on take off due to notenough power. will try it next on 4s.

(Comment from HL) There is plenty of power in the Mig on the stock 3S pack. Most crashes on launch are due to improper technique. You need to throw the Mig straight and level and not up at an angle. You need to push it forward with enough speed to get some airflow over the surfaces.

I love the mig, but I like this mig. The plane flys really well, but the problem in the wings. They attach to the fuse with apoxy. There is no other support. As a result, the wing comes off with the slightest rough landing. Even if you sand the paint off the joints for a better glue surface, the glued on wings are a weak point. The model might benifit from a carbon rod or some other similar wing reinforcement. Either way, the plane flys well and looks amazing in the air.

i like it but i hate how i half to buy it then pay $100 more for a reciever

This model goes together very straightforward and easy. Everything you need to assemble it including the epoxy is there. I did use some sandpaper to clean away the paint from the glue joints, and recommend this in the wing sockets. It would not make much sense to glue to the paint and loose a wing.

I would have given this a five star rating except the bulky hardware on the elevator horns that comes locktited in place. That is good if you use it, but I have always disliked the look of this kind of hardware on the outside. It is redudent since you this kind of connector at the servo. Thankfully they supplied clevi to replace this hardware if desired.

Thank you Hobby Lobby for a value priced complete kit of a great looking jet. Get to fly it tomorrow.

HL's MIG-15 and Sabre offer a lot fun for a few bucks. Check out this video for build and flights.

http://www.youtube.com/watch?v=Yc6ZBdOE2Rc

I am an average pilot and and have been looking for a good starter EDF for some time. I had tried some cheaper models (i.e., Hobby King), but had no success. I have always liked the look of the MIG-15, so this model seemed like a good one to try.

The airplane is very easy to assemble. All components were in good shape and the CG came out perfectly with the supplied battery. I was very happy with the overall kit quality.

I have considerable experience hand launching airplanes, but I was still a little nervous with this one. Luckily, the shape of the plane allows for a good grip, and my first hand launch went perfectly. Just make sure you give it a good straight push - and get a friend to help on the first flights. The flying qualities are very good - good control and not overly sensitive. The only uncomfortable moments came when I performed maneuvers that resulted in a very low airspeed. This happened when I tried a loop without sufficient airspeed. When the plane slowed down at the top of the loop the controls become useless, and the plane tumbled and fell out of control until sufficient airflow was moving over the surfaces. This is the big difference between an EDF and a prop plane, where the prop wash still provides control even with minimal airspeed.

The speed range is excellent - from brisk to a very reasonable landing speed. Landings on grass have been nice and smooth with no damage at all. Another nice thing is the relatively pleasant sound of the motor - my other EDFs had a very shrill squeal that was really unpleasant. This one isn't bad at all.

I really can't think of a single complaint about the model. It is the perfect introduction to EDFs if you have some sport aileron experience, and just make sure you keep the speed up (or fly high!).

You get excellent bang for the buck here. It looks good and is built pretty solid. Plenty of power and very stable. Just be careful and make sure you glue everything together together straight. There is some play when dry fitting the wings and horizontal stabs, so just be sure that everything is centered. Also, be sure to watch Jason's launch video. I wish the flight times were a bit longer, but that is typical of EDFs. Overall, this is an excellent little Mig, and I highly recommend it!

This is a great little jet, not like the F-86 Sabre "Jolley Roger" EPO Jet ARF, this Mig-15 is built much tougher, I really like it...

I just received an email from HL, and they are replacing the damaged parts, they do have the best service I have ever seen. Thank you HL..

I received my Mig-15 with a bad ESC a couple weeks later I received a replacement ESC and my first flight went very well, but then during my second flight the motor shut down and the jet crashed in many pieces, It is so disappointing, I hope that Hobby Lobby does something to help me do to the ESC issues I had from day one.

Awesome job once again from HL. As long as they keep putting out products like these I will keep buying them. They have added carbon rods and a stab stiffener you put in yourself but this is easily a one evening build maybe two for someone with not so much experience with foam jets. The wings and the stab are perfect fits and I even used the included 5 minute tube epoxy which is something I usually don't do. The finish is beautiful and very durable and they went as far as to add an ABS reinforcing ring to the nose intake inlet. That was a very nice touch because their A7 did not have this and any kind of nose low landing tore up the intake. I did make two modifications and these are only a matter of preference not really necessary. I don't happen to like push-rod connectors on my control surfaces because while they do work there is too much risk IMO that they will come loose in flight ending in a very bad day. So I replaced the push-rods with threaded push-rods and clevises and since the same deal exists on the single servo arm I added a servo and used push-rod keepers on this end so now they will not come apart in flight. I used a Spek DX7 and AR500 receiver and mixed the elevator servos and used the included y-harness on the ailerons. It's not really that fast but it's fast enough considering the size and the short amount of time it takes to fly out of visual orientation. Buy this.

Very nice looking MIg and a good flyer once you get the CG right. I upgraded the battery to a 11.1v 2200mah lipo and the plane was still tail heavy. The battery is as far forward as you can get it. I added 1.5oz off lead weight to the nose and now the Mig fly's very well. The CG in the manual is not correct. I moved the CG 1/2in forward from where the manual says and she flys very well there. I hope this help's someone because it took 3 flights before I found the right CG location. After saying that I will admit this is one tough little plane. It nosed it in a couple of times trying to find the correct CG and the Mig just kept on coming back for more. I also had one bad servo in the kit and I just replaced it with a Hitec HS-55. At only $119.00 this is a good deal and a lot of fun to fly.

Pros: Fast, Durable, Looks good, and of course - the price! Just like the Sabre F-86 model, very easy access to the fan and ESC after assembly if you want to upgrade either in the future. Absolutely great for learning to fly EDF jets, or flying where there's nowhere to land but grass.

Cons: My vertical stab was molded a bit crooked, but I fixed this with a 3mm hobby stick. The fan was rubbing (so did my Sabre) I found putting tension on the ESC lines resolved this - since the EDF assembly does not come glued to the plane you need only move them around to fix the problem. I had to adjust the servo's neutral positions because they would dig into the foam when moving, also an easy fix is you have a digital transmitter (the servos are pre-glued and would be gruesome to attempt to reinstall)

Overall I think this is a really nice buy, and has almost enough thrust to lift it's own weight if you have a larger capacity battery installed (2200mah) - so it's pretty fast and decently acrobatic. The assembly is pretty straight forward and easy, but the tail can be a bit tedious. If you're just getting into EDF jets, or just want one to bash and carry around in your trunk for clear days - this is a great plane for the job, it's damn fun!

Foam/paint is great. ESC connections to motor not connected. Not much room for fingers/connections. One hinge on wing not secure. Going to add rudder. Over all looks like a good plane. Build/fly to follow.

Well for $119 I decided to get the Mig-15. I put it together fast and was ready to fly. First flight with stock setup, I threw it straight out and it took off perfectly from my hand launch, straight as an arrow. It flew great as well. Pretty fast for a 3 cell setup! Do be careful when turning, keep your speed up or it will stall and spin on you!

2nd Flight - Hand launch didn't go so well. Plane stalled on launch and flopped around till it hit the ground. Luckily landed on belly and no damage other than a slightly out of place battery tray. Fixed with CA and ready for 3rd flight.

3rd Flight - Hand launch didn't go well again. Plane stalled and flopped around in the air for about 10 seconds. Amazingly I got control before a crash and it zoomed into the air and flew great.

I decided now to add wheels to this jet because hand launching is very tricky. I don't know why my first hand launch was perfect, but my 2nd and 3rd went horribly wrong. I hand launch jets often, and I am an advanced pilot, so my skills aren't to blame. I have CG set exactly as manual says.

4th flight will be with wheels added(I have already added wheels including steering nose gear). Should make this plane fly a little slower with the drag of the wheels, but at least I won't destroy the plane from a hand launch gone bad.

All in all it is a great flying plane. Once speed is up, it soars through the sky and handles well. It landed easy in the grass too. Just keep your wings level to the ground and glide in for a smooth landing.

I gave 4 out of 5 stars because of how hard it is to launch. But it flies great once in the air.

I want to give this a 5 stars just for the fast processing & shipping it took less than 2 days to receive this package, I have been reading that it has had a lot of faulty servo with this particular kit so I'm going to have to check the servos out.

Mike

Props again for fast processing & Shipping of this product HL :)

First time order with hobby lobby, got the plane in 4 days fast shipping, plane looks great out of the box went together in about a hour, charged battery tested electronics everything worked great, only problem i had was the first flight i tried hand tossing it and it went to the dirt then I had someone else hand toss and got it in the air and found it needed trimmed allot but i got trimmed then tossed and so far i have flown it 5 times and no crashes the plane is great its not a rocket ship but does cover distances very quickly fun little jet for the money and the thing is super tough it will be one i will keep for a long time.