Adjust the speed of a servo |
1-1/4 x 7/16 x 3/16" (30 x 10.5 x 6mm), weighs 3.6 grams. Tiny unit allows you to adjust the speed of any proportional servo from.7 seconds to 14.7 seconds in 16 steps. This new version allows higher input voltage of up to 7.0V and also has the signal detection limit set 1V lower than the NFSD1. This makes this unit more compatible with Futaba and Spektrum 2.4 GHz systems. Plug module into the receiver channel that you want to control, plug the servo into module, and adjust the speed using the screw on the side of module. Great for setting scale speed on retracts (with proportional servo) or scale speed for operating flaps. The longer transition times are ideal for marine models. Can be used to slow the operation of 2 servos with the addition of a "Y" connector.
Small, 1 plug in, 1 plug out, 1 screw to adjust speed, works great ! needed to slow servo to fire my cannons, worked perfect !!!!!
|
Simple to set up. Very small and light weight. Used for flaps and tailwheel retract servos to get just the right speed. I will use these modules again in the future.
|
Used this on my Eurofighter landing gear to keep the servos from stripping. It has been working very well over many flights and the retraction/extension of the gear looks more scale. Great product.
|
I'M VERY IMPRESSED WITH THIS SERVO SLOW DOWN. HAVE IT INSTALLED IN MY BIG P-51D MUSTANG AND IN MY P-47 THUNDERBOLT. THE RETRACTS GO UP AND DOWN VERY GENTLE REDUCING CRACKS IN THE GEAR AREA FROM SLAMMING AND BANGING IN.ALSO ITS EASIER ON THE SERVOS PREVENTING STRIPPING AND KEEPS THEM FROM LOOSENING UP ESPECIALLY IN FOAM.. IF YOU HAVE RETRACTS THIS IS THE WAY TO GO. TWO PLUGIN, INLINE CONNECTIONS AND YOUR DONE.KENNY,CAPE COD,MA.
|
|
Write Your Own Review |
Read All Reviews...
|
Please call our support line toll free: (866) 512-1444 for assistance with this product
|