"TB-20" Brushless RTF

41" wingspan, 30-3/4" long, 256 sq. in. wing area, 19 oz. flying weight. Fuselage and wing are molded bead foam construction; the upper fuselage, cabin and windshield are formed plastic sheet. Horizontal and vertical tails are smooth molded foam parts. Assembly takes about an hour. The main wing is in two parts and must be glued together along with the spar joiner. The vertical fin must be glued in place as well, everything else is assembled with a screwdriver. The powerful OUTRUNNER brushless motor is pre-installed and pre-connected to the speed control. All radio components are pre-installed and ready for use; servos and pushrods are installed and ready to be hooked up. Charge the 2 cell lipo battery with the included cell balancing Lithium charger (requires 12 Volt battery or 12 Volt power supply). The transmitter is a 4 channel, 72 MHz mode 2, with a 6 channel receiver. Wing is reinforced with carbon tube spar. Tricycle landing gear with steerable nose wheel makes takeoffs, landings, and ground handling easy. The airplane has plenty of power and jumps off the runway. Controls are well balanced and the airplane has a very gentle stall, suitable for even very low time pilots.

12 volt DC dedicated Lithium Cell Balance Charger included

4-channel 72 mHz transmitter and neck strap included

Check out the of TB-20 and the done in PDF.