Fun to build and great fun to fly---a great first kit

The new Mini Telemaster kit is a huge step forward in easy to build and fun to fly RC model airplanes. It has the great Telemaster heritage that means that it is an airplane that flies beautifully and with the precision of laser cutting it is an unsurpassed build experience. The kit includes all laser cut wing ribs and the forward portion of the fuselage including the firewall and battery tray. The rear portion of the fuselage is stick built for the lightest weight construction. The wing is diagonally braced for extra resistance to warping and twisting; it adds very little weight but a lot of rigidity. The unique parts alignment pin system provided assures perfect part orientation and speeds the assembly. Each laser cut part pops out of the sheet ready to assemble without any additional sanding or trimming required. There is a large hatch on the top of the fuselage to access the battery, no need to remove the wing. The wing is a bolt on unit, eliminating the hassle of rubber bands. Each kit includes one laser cut model, full size plans, photo-illustrated instructions, bent wire main landing gear, tail wheel, and hardware. This is a perfect match to the eRCBL480S motor and the eRCE025 ESC and 2 of the eRCS800 servos. Flies for over 20 minutes with an 1800-2200mAh 2-cell pack.



Check out this great article on the Mini Telemaster kit in Flying Models Magazine.

Technical Specifications: Length: 32" Wingspan: 45" Flying Weight: 23 oz. Controls: Rudder, Elevator, Throttle Wing Area: 325 sq. in.

Radio
1 - SPM5510 DX5e 5-Channel Transmitter/Receiver Only Mode 2
2 - ERCS800 eRC 8g servos

Motor/Prop
1 - ERCBL480S 480 Size Brushless Outrunner 1000Kv
1 - APC09060SF 9x6 Slowflyer Prop

Motor Controller
1 - ERCE025 eRC 25A Brushless Programmable ESC w/BEC
1 - ERCE02 eRC Electronic Programmer

Battery
1 - YTB21002 Cell 7.4V 2100 mAh 20C Lipo

Charger
1 - IMX10501 B6 Pro 80 Watt Balance Charger for 1-6 Lithium Cells

Accessories
Glue, Solder, Connectors, etc.