V-Diamond All-Wood ARF Electro Parkflyer

Twin tailed pusher plane with Jet-like performance

This item is discontinued and no longer available.
36" wingspan, 33" long, 248 sq. in. wing area, 27 oz. flying weight. Beautifully and totally built from laser cut balsa and plywood. Covered with heat shrink covering and decorated with decals. Airplane assembles in about 4 hours. You can assemble it and fly the same day. Instructions are well illustrated. Torque rods for the ailerons are installed and the hinges in the control surfaces are ready for you to glue in place. Laser cut motor mount is included for your AXI 2212/20 OUTRUNNER. Airplane performs nimbly: take-offs are smooth and control response is quick and predictable. Landings are easy; just hold the nose up (don't worry about stalling because stalls are very gentle) and bleed off the speed until you touch down. Battery hatch is under the nose so you can replace the battery easily. Flight times are around 10 minutes depending on your power usage. For 4 channels: Ailerons, Elevator, Nose Wheel steering and Throttle.

Radio
1 - SPM5500 DX5e Full Range Transmitter, AR500 Receiver, no servos
3 - EKS508 8 Gram Digital Micro Servo

Motor/Prop
1 - PM221220 AXI Gold 2212/20 Outrunner Motor
1 - PE08080E 8x8E Thin Electric Prop
1 - MJ4702 Collet Prop Adapter for 3.2mm Shaft, M5

Motor Controller
1 - JESAP18 Jeti Advance PLUS 18 Amp Brushless Controller
1 - JESAP01 Jeti Advance PLUS Program Card * optional

Battery
1 - PQ18003 "Twenty" 3 Cell 11.1V 1800mAh Lipo Pack

Charger
1 - ETC2500 LiPoly Smart Charger for 1-4 Cells
1 - PQPCM3S PCM GUARD for 3S LiPoly Packs

Acessories
1 - CYM248AP Accessory Pack for V-Diamond
Glue, Solder, Connectors, etc.