Wizard 3D Flying Hydro Kit

Shockflyer that takes to water, land, and air!

16" wide, 30-3/4" long, about 9" tall, 7-1/2 oz. flying weight. "Wizard" flies on just about any surface, land, water, or in the air. Model is all sheet foam construction and is completely pre-decorated. Kit includes carbon fiber for struts, motor mount and pushrods. Glue and tape are included as well as all control hardware and clear instructions. Fully 3D capable and with the motor we recommend the model has amazing vertical performance, zooms across the pond then straight up as far as you like. Takes only a few hours to build. For 4 channels: Rudder, Elevator and Aileron mixed (Elevons) and Throttle. A radio with end point adjustments and exponential is recommended.

Radio
1 - HTR8726 Optic 6 with Electron 6 Ch. Receiver, 2 HS-55 Micro Servos
1 - HTS055 Hitec HS-55 Servos
1 - EF001 Lightenna "72" Micro Antenna

Motor/Prop
1 - PM220454 AXI Gold 2204/54 Outrunner Motor
1 - PM22004 Prop Saver Propeller Adapter for AXI 22 Radial Mount
1 - P08038 8x3.8 APC Slowflyer Prop

Motor Controller
1 - JESAP04 Advance PLUS 4 Amp Brushless Controller
1 - JESAP01 Jeti Advance PLUS Program Card * optional

Battery
1 - PQ03003 Twenty 3 Cell 11.1V 800 mAh LiPo

Charger
1 - ETC2020 Smart Charger for 1-3 Li-Poly Cells
1 - BAT220 JST to Deans Ultra Charger Lead

Accessory Pack
1 - IK4011AP Accessory Pack for Wizard
Includes: Glue, Solder, Connectors, etc.